Absolute entropy

The absolute entropy of a system at a given temperature is its entropy at that temperature relative to its entropy at absolute zero.

The consequence of eq300 is that we can calculate the absolute entropies of substances at any temperature. From eq119,

$$\Delta S=\int\frac{dq}{T}\;\;or\;\;S(T_1)-S(0)=\int_0^{T_1}\frac{dq}{T}$$

For a system at constant volume, \(dq=C_VdT\) (see Q&A below for derivation), so

$$S(T_1)-S(0)=\int_0^{T_1}\frac{C_VdT}{T}\;\;\;\;\;\;\;\;(301)$$

For ideal and real gases, \(C_V\) is a function of temperature and is proportional to \(T^3\) at low temperatures according to the Debye formula. At higher temperatures, \(C_V\) can be approximated as a function described by eq43, where \(C_V=a\Delta T+\frac{1}{2}b\Delta T^2+\frac{1}{3}c\Delta T^3+\frac{1}{4}d\Delta T^4\). Assuming that the gas solidifies into a perfect crystal, \(S(0)=0\), eq301 becomes

$$S(T_1)=\int_0^{T_1}\frac{C_VdT}{T}\;\;\;\;\;\;\;\;(302)$$

Having computed eq302, we can use the value to calculate the absolute entropy of the same substance at other temperatures, for instance,

$$S(298)-S(T_1)=\int_{T_1}^{298}\frac{C_VdT}{T}\;\;\;\;\;\;\;\;(303)$$

Using the same logic, a system at constant pressure is given by

$$S(T_2)-S(T_1)=\int_{T_1}^{T_2}\frac{C_pdT}{T}\;\;\;\;\;\;\;\;(304)$$

If eq301 or eq304 has a temperature range that includes phase transitions, which result in points of discontinuity in \(C_V\) or \(C_p\) (see diagram above), we have to modify the equation (e.g. eq304) as follows:

$$S(T_2)-S(T_1)=\int_{T_1}^{fus}C_{p,s}dT+\frac{\Delta H_{fus}}{T_{fus}}+\int_{fus}^{vap}C_{p,l}dT+\frac{\Delta H_{vap}}{T_{vap}}+\int_{vap}^{T_2}C_{p,g}dT$$

Finally, just as the change of standard reaction enthalpy is \(\Delta H_r^{\circ}=\sum_Pv_P(\Delta H_f^{\circ})_P-\sum_Rv_R(\Delta H_f^{\circ})_R\), the change of standard reaction entropy is:

$$\Delta S_r^{\circ}=\sum_Pv_P(S_m^{\circ})_P-\sum_Rv_R(S_m^{\circ})_R\;\;\;\;\;\;\;\;(305)$$

 

Question

Show that \(dq=C_pdT\) and \(\Delta S(T_{trans})=\frac{\Delta H_{tans}}{T_{trans}}\) for an isobaric process.

Answer

The change in enthalpy for an isobaric process that involves only pV work is given by

$$dH=dq\;\;or\;\;dH=\left(\frac{\partial H}{\partial T}\right)_pdT+\left(\frac{\partial H}{\partial p}\right)_Tdp$$

For an isobaric process, \(dp=0\), so \(dH=dq\) or \(dU=\left(\frac{\partial H}{\partial T}\right)_pdT\). Hence, \(dq=\left(\frac{\partial H}{\partial T}\right)_pdT=C_pdT\).

The change in entropy of a constant pressure system at a transition temperature is:

$$\int dS(T_{trans})=\int\frac{dq}{T_{trans}}=\int\frac{dH}{T_{trans}}$$

Both \(dS(T_{trans})\) and \(dH\) are exact differentials, and therefore, \(\Delta S(T_{trans})=\frac{\Delta H_{tans}}{T_{trans}}\).

 

Next article: Permutation and combination
Previous article: Third law of thermodynamics
Content page of chemical thermodynamics
Content page of advanced chemistry
Main content page

Leave a Reply

Your email address will not be published. Required fields are marked *

Mono Quiz