Stationary state

A stationary state is described by a wavefunction that is associated with a probability density and an expectation value that are both independent of time.

For the time-independent Schrodinger equation, \(\hat{H}\psi =E\psi\), its solutions are stationary states. This implies that stationary states of the time-independent \(\hat{H}\) can be represented by basis wavefunctions but not linear combinations of basis wavefunctions with non-zero coefficients. For example, the wavefunction \(\psi\left ( x,t \right )=\phi\left ( x \right )e^{-iEt/\hbar}\)  describes a stationary state because:

$$\left | \psi\left ( x,t \right ) \right |^{2}=\psi^{*}\psi=\phi^{*}e^{iEt/\hbar}\phi e^{-iEt/\hbar}=\left | \psi\left ( x \right ) \right |^{2}$$

and

$$\left \langle H \right \rangle=\int \psi^{*}\hat{H}\psi dx=\int \phi^{*}e^{iEt/\hbar}\hat{H}\phi e^{-iEt/\hbar}dx=E\int \phi^{*}\phi dx=E$$

whereas \(\psi\left ( x,t \right )=\sum_{n=1}^{2}c_n\phi_n\left ( x \right )e^{-iE_nt/\hbar}=c_1\phi_1\left ( x \right )e^{-iE_1t/\hbar}+c_2\phi_2\left ( x \right )e^{-iE_2t/\hbar}\) does not describe a stationary state because:

\(\left | \psi\left ( x,t \right ) \right |^{2}=c_{1}^{*}c_1\phi_{1}^{*}(x)\phi_{1}(x)+c_{2}^{*}c_2\phi_{2}^{*}(x)\phi_{2}(x)+c_{1}^{*}c_2\phi_{1}^{*}(x)\phi_{2}(x)e^{i(E_1-E_2)t/\hbar}+c_{2}^{*}c_1\phi_{2}^{*}(x)\phi_{1}(x)e^{i(E_2-E_1)t/\hbar}\)

where the last two terms of the RHS of the last equality are time-dependent.

If \(\phi_!\) and \(\phi_2\) describe a degenerate state, where \(E_1=E_2=E\), then \(\psi\left ( x,t \right )\) describes a stationary state. Since an observable of a stationary state, e.g. \(H\), is independent of time, every measurement of \(H\) of systems in such a state results in the same value \(E\).

 

Next article: dirac bra-ket notation
Previous article: ground state
Content page of quantum mechanics
Content page of advanced chemistry
Main content page

Leave a Reply

Your email address will not be published. Required fields are marked *

Mono Quiz